ZF6 reverse light switch
Thread Starter
Melting Slicks
Joined: Apr 2000
Posts: 2,793
Likes: 46
From: Elizabeth City, NC
ZF6 reverse light switch
My reverse lights are out on my 94, and it's not the bulbs. So I am figuring that it's just the reverse light switch that is in the tranny. Is there any trick to changing the switch? Just wondering is there is some weird rod or spring that is going to shoot out of the hole when I remove the actual switch? Seems straight forward, but I hate to have to remove the tranny again to get it all back together. Any tips or advise? 
Race Director
Joined: Oct 2002
Posts: 10,864
Likes: 196
From: Southern CA
I think if you can get a lift you can do it without dropping the slave, if your hands are not too big.
On your back I believe these guys are right.
It's not complicated, just hard to get to (what isn't)
On your back I believe these guys are right.
It's not complicated, just hard to get to (what isn't)
Cruising
Joined: Jan 2002
Posts: 12
Likes: 0
From: Cleveland Ohio
Get yourself an offset 7/8 in box-end wrench. That will loosen the old one, so you can pull it out. The hardest part is threading on the new one, due to the slave being soooooo close. Once it is threaded in, slip the wrench back on and give it a tug to snug it up. All done!
