More Plenum Pull Questions
Thread Starter
Instructor
Joined: Jan 2006
Posts: 158
Likes: 0
From: Houston Texas
More Plenum Pull Questions
What would be the torque for the water pump bolts? couldn't find it any of the three books.
The new sensors have sealant on them however when I put them in as they were going in it seem to flake a little but still pliable it seems... Should I be concerned?
What if any type of sealant should be used for the water pump & gasket? (I ordered gasket today from WR)
Thanks Again For all the Invaluable info!
Luis
The new sensors have sealant on them however when I put them in as they were going in it seem to flake a little but still pliable it seems... Should I be concerned?
What if any type of sealant should be used for the water pump & gasket? (I ordered gasket today from WR)
Thanks Again For all the Invaluable info!
Luis
Race Director
Joined: May 2000
Posts: 17,101
Likes: 5
From: No more yankee my wankee, the Donger is tired!
20 ft lbs for all the WP pump bolts, no sealant needed.
For the sensors in the injector housings, any type of sealant that is rated sensor safe and good for coolant.
For the sensors in the injector housings, any type of sealant that is rated sensor safe and good for coolant.
Thanks!
