Kenne Bell
Thread Starter
Instructor
Joined: Mar 2005
Posts: 104
Likes: 0
From: West Monroe Louisiana
Kenne Bell
I recently installed a kenne bell on my 03 z06 and was needing help working out a few tweaks. I keep getting a annoying code, p1441. I ordered a new hose and evap purge solenoid, which has not arrived yet to hopefully fix this. My gas cap was tight. Any other ideas? Also, I keep getting this annoying popping/cracking noise in the rear. I've done everything I know. It's not the sway bar for sure or the rear splines ( I've greased them) I ordered 08 z06 shocks to hopefully resolve this. Any ideas for this? Thanks!
Instructor
Joined: Jun 2005
Posts: 175
Likes: 0
From: Charleston South carolina
KB and poping and cracking!
If it's like mine after my KB install you'll end up with lots of problems back there. Starts with a new built diff then clutch or tranny in my case with an A4. Price you pay for TORQ!
May want to check your rear wheel bearings.
May want to check your rear wheel bearings.
Instructor
Joined: Nov 2004
Posts: 190
Likes: 0
From: Pittsburgh Pennsylvania
kb evap sol
Had the same 1441 code.....bought a new solenoid.....still had the 1441 code.......I also cleaned the original solenoid (used air via my compressor)......problem was in the connections the solenoid snaps into.....there was nothing in particular other than it looked good but wasnt....in addition the manual said to reverse the solenoid when you connect it (said that it works in either direction)......well I put it back so the flow through the solenoid was as it came from the factory....so along with the connection it solved the problem.
