Coil setups??
Burning Brakes
Joined: Feb 2004
Posts: 885
Likes: 0
From: Point Pleasant wv
But a forum member sold me a set of MSD coil packs for a ls2 and told me was a ls1 set up. They did plug up but my car ran like shi$. I had to pull them off and said wouldnt do this again for a upgrade.
Le Mans Master
Joined: Feb 2007
Posts: 6,674
Likes: 57
From: Mt Pleasant, TN
Safety Car
Joined: Jan 2008
Posts: 4,797
Likes: 52
From: Boise
Team Owner
Joined: Jan 2007
Posts: 29,063
Likes: 1,839
From: cookeville tennessee
Yes buy was not for a ls1 set up. I didnt know about the pig tail or doing the wires diff. And the guy I got them from told me was for a ls1, then wouldnt give me my money back.
If I remember I gave you the # off of them and you told me was correct for your car are set up. 
How are they doing on the car for you. If they where the correct one,s I would still have them on the car....
Burning Brakes
Joined: Feb 2004
Posts: 885
Likes: 0
From: Point Pleasant wv
Yes buy was not for a ls1 set up. I didnt know about the pig tail or doing the wires diff. And the guy I got them from told me was for a ls1, then wouldnt give me my money back. If I remember I gave you the # off of them and you told me was correct for your car are set up. How are they doing on the car for you. If they where the correct one,s I would still have them on the car....
Race Director
Joined: May 2005
Posts: 15,960
Likes: 21
From: West Norriton PA
St. Jude Donor '08
I've got a set of LS2 Coils, brackets and harnesses sitting around in my garage along with a set of Katech Valve Covers.
I had originally, bought a set of Katech Valve covers with the Coil Extenders for LS1/LS6 coils but found out when I went to install them that they stood to high because the MSD coils need a 3/8" spacer to work with the brackets. I ended up selling these off and bought the following;
So if anyone is looking for a new set of red powder coated Katech Covers, LS2 Coils and Extended Coil Brackets with the extended MSD wires drop me a PM and I'll grab you some pictures.
Haven't had time to post these up yet for sale. The LS2 coils are smaller.
Also have and extra set of LS2 brackets.
And one set w/brackets and harness.
I had originally, bought a set of Katech Valve covers with the Coil Extenders for LS1/LS6 coils but found out when I went to install them that they stood to high because the MSD coils need a 3/8" spacer to work with the brackets. I ended up selling these off and bought the following;
So if anyone is looking for a new set of red powder coated Katech Covers, LS2 Coils and Extended Coil Brackets with the extended MSD wires drop me a PM and I'll grab you some pictures.
Haven't had time to post these up yet for sale. The LS2 coils are smaller.
Also have and extra set of LS2 brackets.
And one set w/brackets and harness.
