Remove Alky pump but not bracket
Melting Slicks
Joined: Jan 2008
Posts: 2,590
Likes: 48
From: Nathalie VA
St. Jude Donor '15-'16-'17-'18
I'm pretty sure you have to remove the mount as it's attached to the pump from the back side. The pump would rattle around a lot if you left the screws loose that are holding it to the mount.
I could be wrong....It was last winter when I took mine loose.
I could be wrong....It was last winter when I took mine loose.
Drifting
Joined: Feb 2002
Posts: 1,327
Likes: 257
From: Oklahoma City OK
Funny, I just did this to send mine back for rebuild. I think you need to remove all 4 mounting screws that hold the bracket to the frame. The bolts holding the pump to the bracket are small and in the back center of the plate. I don't think you can get to them without removing the bracket from the frame.
Team Owner
Joined: Sep 2001
Posts: 23,283
Likes: 906
From: Lake Elsinore, CA
As I usually do (if it's possible), I tossed the self-tapping screws on my Alky pump and used nutserts to mount it. A PITA, admittedly, but I trust and prefer them over self-tapping hw - makes r&r less frustrating.
Drifting
Joined: Feb 2002
Posts: 1,327
Likes: 257
From: Oklahoma City OK
I had the same thought when I saw the self tapping screws
Thread Starter
Drifting
Joined: Mar 2011
Posts: 1,823
Likes: 43
From: East Aurora NY
