A&A D1SC kit...
Thread Starter
Race Director
Joined: Dec 2002
Posts: 10,233
Likes: 21
From: Baltimore suburbs Maryland
A&A D1SC kit...
... says it needs some minor cutting and welding... just wondering what this might be. I really like the idea of the single intercooler and the over the top intake.
Instructor
Joined: May 2002
Posts: 168
Likes: 17
From: Wichita KS
Re: A&A D1SC kit... (eRiCdWoNg)
You have to cut off the lower radiator support and weld it on further up on the rails. I could not find someone who felt confedent welding on a Corvette in my area so I have the tabs welded on the bar out of the car then bolted it back in. You have to chop your radiator top support, throw out the air cover that directs air to your radiator and move your airpump. You also cut off some plastic to run the piping to the intercool and you have to grind off some of your frame to make it fit right... I just finished mine see: http://forums.corvetteforum.com/zerothread?id=622227
