Notices
C5 General General C5 Corvette and C5 Z06 Discussion not covered in Tech

pulling carpet

Thread Tools
 
Search this Thread
 
Old Feb 21, 2005 | 11:18 AM
  #1  
worldtraveler's Avatar
worldtraveler
Thread Starter
Melting Slicks
15 Year Member
 
Joined: Jan 2004
Posts: 2,546
Likes: 2
From: Proud dad of 2 responsible adults and 1 fallen warrior txtx
Default pulling carpet

Been following the trials and tribulations of EnglandGreen sound proofing before stereo install thread (thanks for the details EG) and it got me to wondering what was involved to remove the carpet and reinstall? Is it glued or what?
Reply
Old Feb 21, 2005 | 11:51 AM
  #2  
screw991le's Avatar
screw991le
Race Director
10 Year Member
 
Joined: Sep 2004
Posts: 17,786
Likes: 4
From: Redsox, Pats, Celts & Bruins !!! Redsox Nation !!!
St. Jude Donor '06-'07-'08-'09-'10-'11-'12
Default

I have only done the rear section, is just lifts right up. The plastic trim is the only thing holding the rear section down.

Its easy, good luck.
Reply
Old Feb 21, 2005 | 04:16 PM
  #3  
14U2ENV's Avatar
14U2ENV
Melting Slicks
15 Year Member
 
Joined: Jun 2004
Posts: 2,404
Likes: 0
From: Lino Lakes, MN _________________________ I Figured out how to do this!
St. Jude Donor '04-'05-'06
Default

Originally Posted by screw991le
I have only done the rear section, is just lifts right up. The plastic trim is the only thing holding the rear section down.

Its easy, good luck.



Same with the fronts, no glue, just the plastic molding holding it in place.
Reply
Old Feb 21, 2005 | 04:45 PM
  #4  
Grumpy's Avatar
Grumpy
MONARTOR
20 Year Member
Veteran: Army
St. Jude 20 Year Donor
Top Answer: 1
 
Joined: Aug 2001
Posts: 249,757
Likes: 146
From: What I know, is dwarfed by what I pretend to know
Cruise-In 5-6-7-8 Veteran
St. Jude Donor '03 thru '26
NCM Sinkhole Donor
Default

Originally Posted by 14U2ENV


Same with the fronts, no glue, just the plastic molding holding it in place.
Reply
Old Feb 21, 2005 | 05:08 PM
  #5  
ALX99's Avatar
ALX99
Burning Brakes
 
Joined: Jan 2002
Posts: 961
Likes: 0
From: Drive for Five N.J.
Default

very simple, pull off the rocker trims, remove the dead pedal and gas pedal stop, remove the seats of course, then just pull them out slowly, careful on the pass side not to break that little vent on the trans tunnel. It's very simple, email me if you have any questions...
Reply
Old Feb 21, 2005 | 05:36 PM
  #6  
Ragin'Cajun's Avatar
Ragin'Cajun
Pro
10 Year Member
 
Joined: Sep 2004
Posts: 652
Likes: 0
From: Katy Tx
Default

The whole interior is easy to take out, just take your time. If something is hanging up when you pull on it, stop and figure out what is hanging up before tuging on it more - that is when stuff breaks. I insulated the front and rear of my coupe with no problems, just start in the morning and plan to do it all day. The only thing that was broken on mine was my pass. sun visor, when a friend who was helping me was putting the seat back in. He didn't realize he was pushing against the visor with the seat and broke it- wouldn't have happened if he was paying attention.

You should be happy with the results, just take your time.
Reply
Old Feb 21, 2005 | 05:40 PM
  #7  
worldtraveler's Avatar
worldtraveler
Thread Starter
Melting Slicks
15 Year Member
 
Joined: Jan 2004
Posts: 2,546
Likes: 2
From: Proud dad of 2 responsible adults and 1 fallen warrior txtx
Default

thanks everyone. sounds too easy to be true. Guess I'll have to bite the bullit and try this next time the rainy season sets in. Weather is too nice not to drive right now.
Reply
Old Feb 21, 2005 | 05:48 PM
  #8  
Z06-JIM's Avatar
Z06-JIM
Race Director
 
Joined: May 2003
Posts: 19,105
Likes: 2
From: Paducah KY
Cruise-In VII Veteran
Default

Originally Posted by ALX99
very simple, pull off the rocker trims, remove the dead pedal and gas pedal stop, remove the seats of course, then just pull them out slowly, careful on the pass side not to break that little vent on the trans tunnel. It's very simple, email me if you have any questions...
I removed all carpet, seats, center console, & trim to install Dynomat Extreme. Also removed door panels and dynomatted the doors.
Everything combined made a huge improvement in interior sound quality of car.
Reply
Corvette Stories

The Best of Corvette for Corvette Enthusiasts

story-0

150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter

 Joe Kucinski
story-1

8 Coolest Corvette Pace Cars (and Replicas) of All Time

 Verdad Gallardo
story-2

Top 10 Corvette Engines RANKED by Peak Torque (70+ Years of Muscle!)

 Joe Kucinski
story-3

Corvette ZR1X Will Be Pacing the Indy 500, And Could Probably Race, Too!

 Verdad Gallardo
story-4

Top 10 Corvettes Coming to Mecum Indy 2026!

 Brett Foote
story-5

Top 10 C9 Corvette MUST-HAVES to Fix These C8 Generation Flaws!

 Michael S. Palmer
story-6

10 Revolutionary 'Corvette Firsts' Most People Don't Know

 Joe Kucinski
story-7

5 Reasons to Upgrade to an LS6-Powered Corvette; 5 Reasons to Stay LT2

 Michael S. Palmer
story-8

2027 Corvette vs The World: Every C8 vs Its Closest Competitor

 Joe Kucinski
story-9

10 Most Common Corvette Problems of the Last 20 Years!

 Joe Kucinski
Old Feb 22, 2005 | 06:20 PM
  #9  
Vetteman Jack's Avatar
Vetteman Jack
Administrator
Supporting Lifetime
Veteran: Navy
St. Jude 20 Year Donor
25 Year Member
Veteran: Reserves
 
Joined: Mar 2001
Posts: 367,758
Likes: 24,681
From: In a parallel universe. Currently own 2014 Stingray Coupe.
C7 of the Year - Modified Finalist 2021
MO Events Coordinator
St. Jude Co-Organizer
St. Jude Donor '03 thru '25
NCM Sinkhole Donor
CI 5, 8 & 11 Veteran
Default

It is not glued down. Should come right up when you get the trim pieces off.
Reply
Old Feb 22, 2005 | 06:48 PM
  #10  
Stock Man's Avatar
Stock Man
Race Director
20 Year Member
 
Joined: Oct 2002
Posts: 11,945
Likes: 12
From: Vancouver
2015 C5 of Year Finalist
St. Jude Donor '05-'06-'07-'08-'09-'10
Default

Do a review when you do it. We love to see these things in progress. Pics are good too.
Reply

Get notified of new replies

To pulling carpet





All times are GMT -4. The time now is 10:51 AM.

story-0
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter

Slideshow: From C1 to C8 we compare every Corvette generation by the numbers.

By Joe Kucinski | 2026-05-12 16:54:12


VIEW MORE
story-1
8 Coolest Corvette Pace Cars (and Replicas) of All Time

Slideshow: Some Corvette pace cars became collectible legends, while others perfectly captured the look and attitude of their era.

By Verdad Gallardo | 2026-05-11 09:50:51


VIEW MORE
story-2
Top 10 Corvette Engines RANKED by Peak Torque (70+ Years of Muscle!)

Slideshow: Ranking the top 10 Corvette engines by torque output.

By Joe Kucinski | 2026-05-05 11:58:09


VIEW MORE
story-3
Corvette ZR1X Will Be Pacing the Indy 500, And Could Probably Race, Too!

Slideshow: A Corvette pace car nearly matching IndyCar speeds sounds exaggerated, until you look at the numbers.

By Verdad Gallardo | 2026-05-04 20:03:36


VIEW MORE
story-4
Top 10 Corvettes Coming to Mecum Indy 2026!

Among a rather large group of them.

By Brett Foote | 2026-05-04 13:56:44


VIEW MORE
story-5
Top 10 C9 Corvette MUST-HAVES to Fix These C8 Generation Flaws!

Slideshow: the top 10 things Corvette owners want in the C9 Corvette

By Michael S. Palmer | 2026-04-30 12:41:15


VIEW MORE
story-6
10 Revolutionary 'Corvette Firsts' Most People Don't Know

Slideshow: 10 Important Corvette 'firsts' that every fan should know.

By Joe Kucinski | 2026-04-29 17:02:16


VIEW MORE
story-7
5 Reasons to Upgrade to an LS6-Powered Corvette; 5 Reasons to Stay LT2

Slideshow: Should you buy a 2020-2026 Corvette or wait for 2027?

By Michael S. Palmer | 2026-04-22 10:08:58


VIEW MORE
story-8
2027 Corvette vs The World: Every C8 vs Its Closest Competitor

Slideshow: 2027 Corvette lineup vs the world.

By Joe Kucinski | 2026-04-24 16:12:42


VIEW MORE
story-9
10 Most Common Corvette Problems of the Last 20 Years!

Slideshow: 10 major Corvette problems from the last 20 years.

By Joe Kucinski | 2026-04-14 16:37:05


VIEW MORE