When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
As I recall from last years's rallies there are lots of C5 tail light mods done out there. Flush mounts, black outs, overlaid grills, etc., but I don't recall ever seeing the sequential tail light signals ever in person.
Are these as infrequent as I am thinking? I did order some last week.
Pull your flame suit uptight. This has been beat pretty hard lately.
I have them and really like them. Also installed 3rd brake light flasher. Really backs off the tail gators
I liked the sequential look so much on my Camaro, I bought six pricy LED brakelight "bulbs" from LEDtronics to enhance the snappiness of the effect. IMHO, the sequentials look great if you have three lights under the same light cover, it gives a nice rolling motion. I've seen the lights on LT1 Impalas, 4th Gen F-bodies, and Mustangs, and it looks nice.
i did it last week..and like it...set it up with the euros...it's different...personal preference...i made a little video for the supplier...but apparently it wont pull up on his 'puter...
i did it last week..and like it...set it up with the euros...it's different...personal preference...i made a little video for the supplier...but apparently it wont pull up on his 'puter...
i'd love to see sequential euros...maybe you can find someplace else to host the video?
that's what i'm worried about...if i saw sequentials in euro i'd probably have to get me a set!!!
were the sequentials plug-and-play just like stock lenses or did you have to do anything different to get them to work?
yes...plug and play...i had several concerns over the compatability of the "Euro" setup and sequentials... emailed Larry several times over this..took photos of the euro install and sent him the photos of the new tail light fixtures and sockets...no real issues arose...
i did have to turn the left (drivers side) sequential module around...(upside down) so that the sealed end was facing up and the open end was facing down...for water and moisture issues...this was done per Larry, the manufact. of the sequential units.
also, the sequential sockets are exactly like the stock sockets...one of the turn signal (euros) tabs and indents were slightly offset...very slightly..had to push in and turn in a bit to lock and seat them...the entire install of the sequetials was 10 minutes..it took longer to open the box and read the instruction..hehehe
PM me your email...i'll go out and make a smaller vid and email it to you..
i personally luv the look...
peace..
got it down to 1.3mgs..
I FORGOT TO ADD...IT ADDED 15 PONIES...
Last edited by usd2sing; Feb 22, 2005 at 01:51 AM.