Mirror Leds
Thread Starter
Team Owner
Joined: Dec 2003
Posts: 21,847
Likes: 140
From: When all is said and done... there is a hell of a lot more said than done. Riverside,Texas
St. Jude Donor '05 thru '26
Mirror Leds
I think we can light all Leds and have them bright. There appears to be 1 positive and 2 current limited negs furnished to the PCB. I divided up to load to have 3 each Leds lit off each circuit. I've had this installed for a while without any problems. It does require opening the etched circuit in 2 places and 3 jumpers. Excuse the cold solder joints as I was in a hurry.
Hope these pics load as I changed ISP recently.
Hope these pics load as I changed ISP recently.
Last edited by ben dover; Mar 8, 2005 at 05:39 PM. Reason: pic load
Safety Car
Joined: Dec 2002
Posts: 4,010
Likes: 1
From: SE Idaho
St. Jude Contributor
One way. I have designed a new board doing basically the same thing; three LEDs per circuit. Just waiting to run up to the electronics store and purchase the bare boards, then etch the new diagram into place. Then I'll just transfer the small connector over to the new board.
Your way is faster, mine will be more fun....
Your way is faster, mine will be more fun....
Last edited by WhiteC5Vette; Mar 8, 2005 at 05:56 PM.
