2 Vettes...2 different problems
Thread Starter
Racer
Joined: Nov 2003
Posts: 397
Likes: 1
From: Bedford TX
2 Vettes...2 different problems
I need some help from the experts. First off my wifes 03 AE had the check engine light come on yesterday. Everything appears to be ok, oil pressure, temp and charging, ect. Just turned about 38k. Don't know how to bring up the codes to find out what the problem could be. Any ideas would be appreciated. Also, my 02 had a diff. change about 3 mo. ago. Alls been fine until a couple days ago when every time I go from drive to reverse I hear 2 audible clicks. Could it be CV joints? Rides good except for that. By the way, I went from 2.73's to 3.42's Any ideas guys? 
Le Mans Master
Joined: Dec 2003
Posts: 5,622
Likes: 0
From: Savannah Georgia
Cruise-In VIII Veteran
You can up your Codes and post what you find
Pull Codes
as far as the clicking I was told to tighten the wheel nut. I had a simular problem, but mine was the boot clamp on the output shaft was hittting the brake line
Pull Codes
as far as the clicking I was told to tighten the wheel nut. I had a simular problem, but mine was the boot clamp on the output shaft was hittting the brake line
Race Director
Joined: Nov 2003
Posts: 12,346
Likes: 5
From: Mustang OK
Originally Posted by 1Patriot
On your wife's, make suure the Fuel fill cap is on tight. It will set a code if it is loose and the engine is running. Reset the code and all is well.
A gas cap that has been improperly installed or a cap with a bad seal can cause the Check Engine Light to display. In case of a bad seal, the cap will need to be replaced.A steady Check Engine Light is very likely an indication of an emission control system malfunction (possibly due to the gas cap). A flashing Check Engine Light may indicate a misfire or more serious problem. I would recommend that you read that portion of your Owner's Manual concerning the Check Engine Light, especially the sections about If the Light Is Flashing and If the Light Is On Steady. (This should be covered in Section 3, Instrument Panel under Warning Lights, Gages, and indicators in your manual.) Hopefully reading these sections along with checking your car's trouble codes will give you a clearer indication as to your problem.
Also, The following site has the Diagnostic Trouble Codes (DTCs) specific to each model year: Computer Codes For 1981 - 2003 Corvettes.
Good luck with the repairs.
Last edited by GrayC5; Apr 23, 2005 at 12:26 AM.
Thread Starter
Racer
Joined: Nov 2003
Posts: 397
Likes: 1
From: Bedford TX
Originally Posted by navy99vert
You can up your Codes and post what you find
Pull Codes
as far as the clicking I was told to tighten the wheel nut. I had a simular problem, but mine was the boot clamp on the output shaft was hittting the brake line
Pull Codes
as far as the clicking I was told to tighten the wheel nut. I had a simular problem, but mine was the boot clamp on the output shaft was hittting the brake line
MONARTOR
Joined: Aug 2001
Posts: 249,967
Likes: 146
From: What I know, is dwarfed by what I pretend to know
Cruise-In 5-6-7-8 Veteran
St. Jude Donor '03 thru '26
NCM Sinkhole Donor
Originally Posted by 1Patriot
On your wife's, make suure the Fuel fill cap is on tight. It will set a code if it is loose and the engine is running. Reset the code and all is well.
