Fog Light Screens
Drifting
Joined: Sep 2006
Posts: 1,387
Likes: 30
Never saw those before, but its pretty much a matter of taking off the original ones. Its not that hard. Just go under there are unbolt them and take em' out. Might have to remove the fog lights but thats not that hard either, just taking out the connector can be tricky.
not that hard
Burning Brakes
Joined: Aug 2006
Posts: 753
Likes: 2
From: Denville NJ
Did my Vararam air system recently and basically you have to remove the stock fog light shroud. It will be almost mandatory to drive up on ramps. My C5 only uses only the center air dam so it goes up to rino-ramps easily. There is a bunch of small hex head screws, 7mm I think that you need to remove from one tire to the other. It will be more obvious when you get into it. Once the lower covers are off you will need to fiddle with the brake air tubes and twist them out. By this time you will see the one bolt on each side that holds the fogs in place and the few screws that hold the shrouds in place. While you are under there you may want to renew or upgrade your fogs to higher wattage as well as install fresh signal and running bulbs.
By the end of it all you may think, like many have, that heck I could have just hollowed out the stock units!! Have fun....
By the end of it all you may think, like many have, that heck I could have just hollowed out the stock units!! Have fun....
