Good Shop?
Thread Starter
Racer
Joined: May 2007
Posts: 424
Likes: 0
From: Redmond Washington
Good Shop?
So apparently my oil sensor went out this morning and I don't want to go too long without replacing it. After looking though the DIY threads and seeing that I'd have to take apart half my engine to replace it 
was wondering if anyone can recommend a good shop near Seattle, WA that could do it before I call the local dealer...
Thanks!
was wondering if anyone can recommend a good shop near Seattle, WA that could do it before I call the local dealer...Thanks!
Race Director
Joined: Feb 2008
Posts: 17,336
Likes: 8
From: Maker of Sharp Objects, AL - Roll Tide
St. Jude Donor '10-'11-'12-'13-'14-'15-'16-'17
St. Jude Knife Maker
There is also a thread and I don't know if you saw it, but it involves cutting a small hole in the center area under the wiper cowl. it was pretty easy; its what I did to save money on the repair. You can't even tell after the cowl is put back in place and it worked out fine for me. Of course some don't want to cut on their cars. 
