HVAC info needed
Thread Starter
Racer
Joined: Aug 2007
Posts: 497
Likes: 0
From: Monrovia California
HVAC info needed
Upon starting my display lights up very dim & darker in the corners but after a few minits it brightens up to match sterio normal or not I dont recall seeing it do this in the past
Melting Slicks
Joined: Jul 2004
Posts: 3,294
Likes: 480
From: Brea CA
There are 6 resistors on a circuit board inside that have bad solder joints. Easy fix, re-solder them and good as new. If you want to do it your self search for "Dim HVAC" on this forum. It has been discussed many times.
If you need help doing this just PM me.
Gary
If you need help doing this just PM me.
Gary
Thread Starter
Racer
Joined: Aug 2007
Posts: 497
Likes: 0
From: Monrovia California
thanks for the offer to help Ive been through NASA hand soldering school years ago and I'm confident on the repair I was just wondering about the dim then bright i didnt think anything needed to "warm up". Thanks again I'll get it done in the AM.
Le Mans Master
Joined: Aug 2001
Posts: 6,213
Likes: 1
From: South Alabama
