Notices
C5 General General C5 Corvette and C5 Z06 Discussion not covered in Tech

A4 Performance/Longevity

Old Dec 4, 2008 | 07:30 PM
  #1  
Dominic Toretto's Avatar
Dominic Toretto
Thread Starter
Race Director
 
Joined: Jul 2007
Posts: 11,467
Likes: 8
From: 972 and 405
Default A4 Performance/Longevity

After reading another thread, I was not able to find out the exact answer to my question. What is the best way to "drive" an A4 transmission for best longevity. Some drive it in the city on "3" and others keep it in OD. I know in general, for performance cars, autos do not last as long as the manual counterparts. I currently keep mine in OD at all driving times. Is this best practice or should I be doing something else?

-Alex
Reply
Old Dec 4, 2008 | 07:57 PM
  #2  
dobewillie's Avatar
dobewillie
Race Director
 
Joined: Mar 2006
Posts: 10,477
Likes: 4
From: lockport n.y
Default

Im an od guy on rare occasions I get crazy and drop her down 1
Reply
Old Dec 4, 2008 | 07:58 PM
  #3  
damilleniumboy's Avatar
damilleniumboy
Le Mans Master
15 Year Member
 
Joined: Jun 2007
Posts: 6,301
Likes: 6
From: LAND OF OZ Kansas
Default

I'm pretty sure the D is for extended and daily driving.
Reply
Old Dec 4, 2008 | 08:07 PM
  #4  
71vetteinva's Avatar
71vetteinva
Racer
 
Joined: Jun 2005
Posts: 438
Likes: 0
Default

The enemy of automatic transmission life is always heat.

If you notice the car shifting from 3rd to 4th frequently, for example hilly terrain or city driving, then it's not a bad idea to shift it out of overdrive. It's never been a problem for me, really, so I just leave it in "D". Needless shifting builds up heat, which reduces the life of the transmission.

In addition, you want those shifts to be as hard and quick as possible, again, less chance for heat to build up. Automatics are set up for lazy shifting from the factory for sheer comfort. That's why shift kits have been known to increase the life of a transmission.

There are no shift kits for our cars, nor is it necessary, since everything is done electronically. I purchased a Diablo Predator for this purpose. My shifts are now short and crisp. It's good for performance and it's good for transmission life.

Last edited by 71vetteinva; Dec 4, 2008 at 08:10 PM.
Reply
Old Dec 4, 2008 | 08:14 PM
  #5  
Dominic Toretto's Avatar
Dominic Toretto
Thread Starter
Race Director
 
Joined: Jul 2007
Posts: 11,467
Likes: 8
From: 972 and 405
Default

Originally Posted by 71vetteinva
The enemy of automatic transmission life is always heat.

If you notice the car shifting from 3rd to 4th frequently, for example hilly terrain or city driving, then it's not a bad idea to shift it out of overdrive. It's never been a problem for me, really, so I just leave it in "D". Shifting needless builds up heat, which reduces the life of the transmission. The decision to leave it in OD is really situation dependent.

In addition, you want those shifts to be as hard and quick as possible, again, less chance for heat to build up. Automatics are set up for lazy shifting from the factory for sheer comfort. That's why shift kits have been known to increase the life of a transmission.

There are no shift kits for our cars, nor is it necessary, since everything is done electronically. I purchased a Diablo Predator for this purpose. My shifts are now short and crisp. It's good for performance and it's good for transmission life.
That's a lot of good information there. During my normal driving I keep my DIC on to monitor the transmission temp, which has never been an issue. And if it ever does rise above 200F then it normally levels back out to a comfortable temp. The manual says 260F is the "no no" area. Also since shifting causes heat, what about running the transmission in a high pace relative to engine speed? Does that not affect it also, in regards to building heat? For example if I cruise around in "3" in the city that will be ~1.2 to 1.5k rpms, as opposed to cruising around at less than 1k rpms.

-Alex
Reply
Old Dec 4, 2008 | 08:24 PM
  #6  
Mr. Jean's Avatar
Mr. Jean
Safety Car
15 Year Member
Liked
Loved
Community Favorite
 
Joined: Dec 2006
Posts: 3,623
Likes: 316
From: Sparks, Nevada
Default

As mentioned, find out what works for you, in the area you drive. What speed are you driving, at what rpm? What is your rear gear ratio and do you find it down shifting or lugging?

If you have 3:15 or better, you can probably get around fine in overdrive. I have 3:15's and prefer 3rd for my style of driving.

Drive it around in D for a few days, watching how often you reach 4th/overdrive. If your not in 4th much, then it really shouldn't matter, as your not building heat by shifting more often, are you.

Edit: I just saw your note about the under 1K driving. I don't like that at all. To me, that is lugging it. I prefer it a little higher than that.

Last edited by Mr. Jean; Dec 4, 2008 at 08:27 PM.
Reply
Old Dec 4, 2008 | 08:27 PM
  #7  
71vetteinva's Avatar
71vetteinva
Racer
 
Joined: Jun 2005
Posts: 438
Likes: 0
Default

Originally Posted by AlexSmith
That's a lot of good information there. During my normal driving I keep my DIC on to monitor the transmission temp, which has never been an issue. And if it ever does rise above 200F then it normally levels back out to a comfortable temp. The manual says 260F is the "no no" area. Also since shifting causes heat, what about running the transmission in a high pace relative to engine speed? Does that not affect it also, in regards to building heat? For example if I cruise around in "3" in the city that will be ~1.2 to 1.5k rpms, as opposed to cruising around at less than 1k rpms.

-Alex
I don't think that would be a big problem. Higher RPM's will generally cause a little more wear and tear on engine components, but it's not that much. I would think wear and tear on the transmission from continually shifting between 3rd and 4th would be greater than slightly higher engine RPM.

Everything is situation dependent. For example, I would think the engine would be under less strain when climbing a mountain in a lower gear, even if RPM is higher.

You may want to look into a tuner to firm up your shifts. That's been proven to help reliability. You don't want all of those clutches in your automatic to slowly "slip" into gear. It builds up heat and increases wear and tear on the components.

Last edited by 71vetteinva; Dec 4, 2008 at 08:33 PM.
Reply
Old Dec 4, 2008 | 08:34 PM
  #8  
Patman's Avatar
Patman
Race Director
25 Year Member
Liked
Loved
Community Favorite
 
Joined: May 2001
Posts: 15,324
Likes: 2,080
From: Guelph, Ontario
Default

I wouldn't imagine that the life of the trans would be affected too much based on your choice of keeping it 3rd in the city or in drive. As mentioned, the big factor in an auto tranny's life is keeping the heat down. I've also heard that specifically with the 4L60E you can prolong it's life quite a lot if you limit the amount of time your engine spends above 6000rpm. Apparently the more often you go beyond 6000, the more stress it puts on the 4L60E.
Reply
Corvette Stories

The Best of Corvette for Corvette Enthusiasts

story-0

5 Best & 5 Most Overrated Corvette Track Packages of All Time!

 Joe Kucinski
story-1

Every 2027 Corvette Engine Explained

 Joe Kucinski
story-2

Designer Imagines A Corvette That Looks More Like a Corvette Than the Corvette

 Verdad Gallardo
story-3

10 Ugly Corvettes That We Still Kinda Love

 Joe Kucinski
story-4

Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer

 Brett Foote
story-5

10 Things Every Corvette Owner Needs (2026 Edition)

 Michael S. Palmer
story-6

8 Most "Only Corvette Owners Understand" Quirks and Problems

 Pouria Savadkouei
story-7

10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years

 Joe Kucinski
story-8

How Much Horsepower Every Corvette Engine "LOST" in 1972

 Joe Kucinski
story-9

Top 10 DOs and DON'Ts for Protecting Your Convertible Top!

 Michael S. Palmer
Old Dec 4, 2008 | 08:44 PM
  #9  
MIKE-C5's Avatar
MIKE-C5
Race Director
 
Joined: Jan 2003
Posts: 19,802
Likes: 0
From: San Antonio Texas
St. Jude Donor '05-'06-'08
Default

Just drive it like ou stole it !
Reply

Get notified of new replies

To A4 Performance/Longevity



Thread Tools
Search this Thread

All times are GMT -4. The time now is 04:48 PM.

story-0
5 Best & 5 Most Overrated Corvette Track Packages of All Time!

Slideshow: The 5 best and 5 most overrated Corvette track packages ever.

By Joe Kucinski | 2026-06-09 12:46:45


VIEW MORE
story-1
Every 2027 Corvette Engine Explained

Slideshow: Every 2027 Corvette engine explained

By Joe Kucinski | 2026-06-09 12:16:31


VIEW MORE
story-2
Designer Imagines A Corvette That Looks More Like a Corvette Than the Corvette

Slideshow: A Jaguar designer's personal project imagines what a modern front-engined Corvette might look like if Chevrolet revisited the golden age of the Stingray.

By Verdad Gallardo | 2026-06-08 19:53:43


VIEW MORE
story-3
10 Ugly Corvettes That We Still Kinda Love

Slideshow: 10 ugly Corvettes that we still kinda love.

By Joe Kucinski | 2026-06-03 10:34:17


VIEW MORE
story-4
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer

A lot of money has changed hands at the online auction house over the years.

By Brett Foote | 2026-06-03 10:21:50


VIEW MORE
story-5
10 Things Every Corvette Owner Needs (2026 Edition)

Slideshow: 10 great gifts Corvette enthusiasts actually want for Father's Day!

By Michael S. Palmer | 2026-06-03 15:43:40


VIEW MORE
story-6
8 Most "Only Corvette Owners Understand" Quirks and Problems

Slideshow: These are the quirks, annoyances, and oddly lovable problems that every Corvette owner eventually learns to live with.

By Pouria Savadkouei | 2026-05-28 09:31:39


VIEW MORE
story-7
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years

Slideshow: 10 reasons why the C6 Z06 is still a performance benchmark after 20 years.

By Joe Kucinski | 2026-05-27 17:20:09


VIEW MORE
story-8
How Much Horsepower Every Corvette Engine "LOST" in 1972

Slideshow: How much horsepower every Corvette engine lost in 1972.

By Joe Kucinski | 2026-05-27 16:54:53


VIEW MORE
story-9
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!

Slideshow: How to Protect A Convertible Top: 10 DOs & DON'Ts

By Michael S. Palmer | 2026-04-03 00:00:00


VIEW MORE