BBK T/B missing hardware
Thread Starter
Racer
Joined: May 2006
Posts: 254
Likes: 0
From: Bradford Ontario
BBK T/B missing hardware
I recently bought a used BBK 80mm throttle body for my 99 vette. It came with the throttle body spacer, gasket, the throttle body itself and a servo motor. What I'm missing is the three socket bolts and the two spacers for the power steering reservoir. Can I get the socket bolts and spacers in a hardware store or should I call BBK?
Melting Slicks
Joined: Mar 2005
Posts: 2,891
Likes: 4
From: North Port Fl
I also bought a used BBK TB that was missing the spacers and a gasket. I bought them from BBK. They cost me over $25. You would be better going to a hardware store and getting a couple of bolts and washers for the spacers. You'll save a lot of money. If I had it to do over again that's what I would do.
Thread Starter
Racer
Joined: May 2006
Posts: 254
Likes: 0
From: Bradford Ontario
I also bought a used BBK TB that was missing the spacers and a gasket. I bought them from BBK. They cost me over $25. You would be better going to a hardware store and getting a couple of bolts and washers for the spacers. You'll save a lot of money. If I had it to do over again that's what I would do.
Thread Starter
Racer
Joined: May 2006
Posts: 254
Likes: 0
From: Bradford Ontario
Yea, my car is in storage too and I can't get to it at the moment. I figure the thread size is the same as stock, but I wouldn't know until I can get my hands on the actual socket bolts. Besides I'm also replacing the LS1 manifold with a LS6 unit.
