[Z06] Science Project Complete!
Thread Starter
Racer
Joined: Dec 2001
Posts: 354
Likes: 0
From: Jax Fl
Science Project Complete!
Well, I'm ready for the dyno tomorrow. Did my last set of ease scans and was amazed that everything tweaked in perfectly with only minor MAFT adjustments. It took a base setting of 10% rich to get my LTFT's to average approx. negative 1.5 and I didn't have to touch my WOT setting as my O2 sensor average was right at .89
Tomorrow night I'll post my dyno sheets good, bad, or ugly. I've got a really good feeling about the numbers I'll see just based on SOTP.........We'll see
:cheers:
Tomorrow night I'll post my dyno sheets good, bad, or ugly. I've got a really good feeling about the numbers I'll see just based on SOTP.........We'll see
:cheers:
Account disabled by user request 2 March 2009
Joined: Jun 2001
Posts: 581
Likes: 0
Re: Science Project Complete! (VettTheRipper)
Can't wait to see your numbers. Sitting here with a MAFT and an EASE scan tool. Was hoping for a 5pin connector for the MAFT before I install. Have done the scans and am 18% lean.
Bob
Bob
Team Owner
Joined: Jun 2001
Posts: 100,672
Likes: 2
From: Cleveland OH
Re: Science Project Complete! (Cape Cod Bob)
Can't wait to see your numbers. Sitting here with a MAFT and an EASE scan tool. Was hoping for a 5pin connector for the MAFT before I install. Have done the scans and am 18% lean.
Bob
Bob
