HELP -with automatic shift boot install
Thread Starter
Burning Brakes
Joined: Aug 2008
Posts: 1,216
Likes: 0
HELP -with automatic shift boot install
I feel like a dumbass asking this, so here goes.
I bought a new shift boot, took off the old one now installing the new one. I fit the gear selector piece into the boot, now I cant figure out where exactly the orange indicator fits in. It is attached to the shifter and protrudes about 3/4". There is a half moon clear plastic piece I assume fits right over the light bulb.
Thanks
I bought a new shift boot, took off the old one now installing the new one. I fit the gear selector piece into the boot, now I cant figure out where exactly the orange indicator fits in. It is attached to the shifter and protrudes about 3/4". There is a half moon clear plastic piece I assume fits right over the light bulb.
Thanks
Racer
Joined: May 2009
Posts: 312
Likes: 2
From: Elizabeth City North Carolina
Yep, clear plastic piece fits over light, the plastic ring glues inside of the boot (make sure it it right side up and the right direction) yes you can put them in upside down and backwards. Don't ask how I know. Once that is glued in attach the biit inside out with a new ziptie, roll it down, snap the plastic ring back into the two clips, roll the boot elastic under the shifter section then button it all back up.
Not sure if that answered your question or not.
Not sure if that answered your question or not.
Thread Starter
Burning Brakes
Joined: Aug 2008
Posts: 1,216
Likes: 0
help
boot and boot ring attaches to gear indicated plastic piece. The as attached to the housing with a clear half moon piece over the light. My question is there is an orange L shaped piece attached to white tube, which slides on the shifter. I assumed the orange piece was to show the gear you are in. How the heck do you install it?
boot and boot ring attaches to gear indicated plastic piece. The as attached to the housing with a clear half moon piece over the light. My question is there is an orange L shaped piece attached to white tube, which slides on the shifter. I assumed the orange piece was to show the gear you are in. How the heck do you install it?
Melting Slicks
Joined: Mar 2005
Posts: 2,891
Likes: 4
From: North Port Fl
