How do you remove the front bumper cover?
Race Director
Joined: Dec 2006
Posts: 12,969
Likes: 2
St. Jude Donor '08-'09-'10
Cruise-In IX Veteran
Remove the pop pins on the top of the bumper, remove the headlight covers and shroud and while the lights are up reach in and remove the nuts that attach to a 2 bolt plate that holds the front bumper and front fender together. After this remove the front air dam and then remove the rest of the lower screws and walla ..its off.
PM me if you need help
PM me if you need help
Former Vendor
Joined: Jan 2008
Posts: 16,312
Likes: 0
From: Surprise Arizona
Remove the pop pins on the top of the bumper, remove the headlight covers and shroud and while the lights are up reach in and remove the nuts that attach to a 2 bolt plate that holds the front bumper and front fender together. After this remove the front air dam and then remove the rest of the lower screws and walla ..its off.
PM me if you need help
PM me if you need help
You will also need to take off the license plate cover because there are two plastic fastners that hold the bumper to the bumper cushion/support.
Melting Slicks
Joined: Nov 2008
Posts: 2,938
Likes: 65
From: Rochester Hills MI
i found its easier to access the 2 bolt plate from the bottom after all the lower access panels and air dam has been removed. also make sure to disconnect your wiring harnesses for the corner lights.
