When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Make your '97-'04 Chevrolet Corvette C5 Coupe, Convertible or Z06
"Tough-looking" with this Bumper, Hood, Roof and Rear Deck Lid Rally Stripe Graphics kit.
Coupe (shown) & Z06 kits come with eleven (11) pieces while the convertible is provided with nine (9) pieces.
They're PRECUT and ready to install in a wide variety of colors - there is NO TRIMMING required!
This stripe package is not just a set of 10" strips in a box.
Our graphic kit consists of prefitted and contoured pieces as shown in the illustration.
Stripe width is approximately 10" (25.40cm) and set for a center spacing of 4" while a .25" (.64 cm) pinstripe borders the outside edge as shown.
How do you apply these with no bubbles or wrinkles?
The way I apply graphics is with soapy water. Just like the window tint people do. After the prep you spray the car where the graphic is going to sit with soapy water. Then spray the back of the graphic and place it on the car where you want it to sit. Then you want it work the water out from under the graphic with a squeegee. After the water is gone the graphic will bond to the car. Its not to hard to do but you only get one try so most people will take it some where to be installed. A window tint shop can do it. Hope this helps. http://www.youtube.com/watch?v=jy73159xW-Q here is a youtube link to see how to install.
Last edited by Stainless Addiction; Jan 15, 2011 at 03:26 PM.