Sequential tail lights ?
Thread Starter
Race Director
Joined: Aug 1999
Posts: 11,123
Likes: 673
From: SE Pennsylvania
St. Jude Donor '03 thru '26
Oldtimer
Sequential tail lights ?
I bought a set of these sequential harnesses for my 2003 rear turn signals. Of course on had a broken wire in it so I need to wait for a replacement. But I was wondering if anyone else has installed these? And they come two to a pack, is that only for one side or do I need to buy four of that four rear tail lights ? Just wondering how the two lights are going to light in sequential order if only one light on each side is equipped with this sequential harness ? They both take a 3057 bulb on all four rear taillights. Thank You !
Thread Starter
Race Director
Joined: Aug 1999
Posts: 11,123
Likes: 673
From: SE Pennsylvania
St. Jude Donor '03 thru '26
Oldtimer
Ok. . .
Thanks for the information.
Instructor
Joined: Feb 2007
Posts: 172
Likes: 2
From: Lafayette IN
Thread Starter
Race Director
Joined: Aug 1999
Posts: 11,123
Likes: 673
From: SE Pennsylvania
St. Jude Donor '03 thru '26
Oldtimer
Sequential lights price.
I still don't understand how one light flashes if the other one in on steady ? I thought the device made both lights flash on and off.
Melting Slicks
Joined: Apr 2001
Posts: 2,119
Likes: 213
From: Pittsburgh PA
Tech Contributor
Joined: Aug 1999
Posts: 16,376
Likes: 404
From: Should this thoughtful, valuable contribution meet with no acknowledgement or 'thanks' this post----
Hey, best luck with the back surgery... Regarding the sequential lights...I have a hard time understanding the sequential nature of just two lights. If the car had three, then it would look sequential. With just two, it looks odd...more like an alternating appearance...almost like a strobe light. 
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Racer
Joined: Apr 2012
Posts: 284
Likes: 3
From: Rochester New York
I paid $124.99 from Mid-America but I have seen them for about $5 cheaper., I had to call in for a replacement it had a broken contact. But Mid-America customer service is sending out a new set ASAP. They always take good care of me.
I still don't understand how one light flashes if the other one in on steady ? I thought the device made both lights flash on and off.
I still don't understand how one light flashes if the other one in on steady ? I thought the device made both lights flash on and off.
Thread Starter
Race Director
Joined: Aug 1999
Posts: 11,123
Likes: 673
From: SE Pennsylvania
St. Jude Donor '03 thru '26
Oldtimer
Sequential lights, OK I'm with you but. . . .
I have found this set up for $99 shipped. The way it works as I understand it is that the harness delays the outside light for a second after the lights are activated. So the inside light lights up and a second or so later the outside light gets power. It gives the appearance that they are sequential.
Last edited by killain; Apr 29, 2012 at 09:11 PM.
Racer
Joined: Apr 2012
Posts: 284
Likes: 3
From: Rochester New York
But doesn't the inside like stay on ? Or does it flash normally ? I mean I've never stood behind my Vette while the turn signals are on, Once I get the replacement I guess I'll understand then / But I just don't understand it right now, but I believe you. While I have the rear lights out I decided to install the third brake light pulsar harness, and that does work just as they say it will, I replaced the stock 3057 with the Sylvania Silver-Star 3057ST premium light bulbs. I'm doing this little projects now, Come next Monday I'll be missing some of my back vertebrata ! Doc's doesn't know when I'll be able to drive again.
Melting Slicks
Joined: Mar 2006
Posts: 2,997
Likes: 36
From: Ocean Springs MS
I bought mine for my C5, & C6, from Webelectric.com along with the center brake light flasher. Think they're a bit cheaper and have a lifetime warranty which is nice. I had one side stop working on my C5 after a couple years and he just told me to send it back and gave me a new one with no hassle at all. 
Thread Starter
Race Director
Joined: Aug 1999
Posts: 11,123
Likes: 673
From: SE Pennsylvania
St. Jude Donor '03 thru '26
Oldtimer
Borken harness.
Both lights flash at the same time normally. The one harness you have should work... have you tried it? When you connect the harness both right (or left) tails will get power to light, but the outside one will get delayed a second or so from the inline harness. See this video. This guy has his 4-ways on but you can see what I mean...
Le Mans Master
Joined: Feb 2003
Posts: 6,683
Likes: 144
From: Memphis Tennessee
I bought mine for my C5, & C6, from Webelectric.com along with the center brake light flasher. Think they're a bit cheaper and have a lifetime warranty which is nice. I had one side stop working on my C5 after a couple years and he just told me to send it back and gave me a new one with no hassle at all.
Melting Slicks
Joined: Oct 2007
Posts: 2,798
Likes: 8
From: It's true money can't buy happiness, but it is more comfortable crying in a Corvette than on a bicyc
St. Jude Donor '13
That's all it does is slightly delay the outer one lighting. I'd say by half a second. The inner blinks at the normal rate. The outer goes out normal but lights slower. Even the emergency flashers delay the outer. I bought mine on ebay years ago for 119. but had a 10% coupon.
Intermediate
Joined: Dec 2012
Posts: 35
Likes: 0
From: Seattle WA
I got mine from DD mods and they work flawlessly, true plug and play, jusk make sure you get the proper seal to prevent water from entering sockets...Its all in the instruction booklet provided by them...I think they look better when you apply the brakes vs. the turn signals...I am going to search the forums on how to slow the turn signals down even father...they do sequence pretty fast... Dont get me wrong I do love them and wont ever take them off..