4 Point Roll Bar
Safety Car
Joined: Dec 2009
Posts: 3,724
Likes: 9
We used to manufacture a product called our Chassis bar. It was a 4 point bar that installed into the rear deck and B pillars, and was fastened in place with Riv Nuts rather than being welded. It provided some improvements to chassis stiffness as well as a safe place to mount either Cameras or Shoulder harness hardware.
We no longer manufacture that particular part, but I do have 2 left over in stock that we can sell. If you're interested shoot us a PM. It comes unfinished, but if you're concerned about the look you can always take the bar to a local powdercoater and have it setup any color you would like.
Shoot me a PM or give us a call at 1-888-972-2464 if you're interested!
Here is a photo of the bars powdercoated red.
We no longer manufacture that particular part, but I do have 2 left over in stock that we can sell. If you're interested shoot us a PM. It comes unfinished, but if you're concerned about the look you can always take the bar to a local powdercoater and have it setup any color you would like.
Shoot me a PM or give us a call at 1-888-972-2464 if you're interested!
Here is a photo of the bars powdercoated red.
Racer
Joined: Jan 2009
Posts: 352
Likes: 0
From: Wichita Kansas
Thread Starter
Melting Slicks
Joined: Jul 2009
Posts: 2,487
Likes: 0
From: China Grove N.C.
We used to manufacture a product called our Chassis bar. It was a 4 point bar that installed into the rear deck and B pillars, and was fastened in place with Riv Nuts rather than being welded. It provided some improvements to chassis stiffness as well as a safe place to mount either Cameras or Shoulder harness hardware.
We no longer manufacture that particular part, but I do have 2 left over in stock that we can sell. If you're interested shoot us a PM. It comes unfinished, but if you're concerned about the look you can always take the bar to a local powdercoater and have it setup any color you would like.
Shoot me a PM or give us a call at 1-888-972-2464 if you're interested!
Here is a photo of the bars powdercoated red.
We no longer manufacture that particular part, but I do have 2 left over in stock that we can sell. If you're interested shoot us a PM. It comes unfinished, but if you're concerned about the look you can always take the bar to a local powdercoater and have it setup any color you would like.
Shoot me a PM or give us a call at 1-888-972-2464 if you're interested!
Here is a photo of the bars powdercoated red.
Drifting
Joined: Dec 2010
Posts: 1,254
Likes: 7
From: Columbus Oh
I put the pfadt bar in my z. I had it powder coated red. Install was not fun, especially in the heat we've had, but it wasnt too terrible. The rivnuts are the hard part. I would recommend an impact gun for them or you'll be cursing pfadt for hours. Very nice piece though.
