[Z06] After much debating over the look
Thread Starter
Safety Car
Joined: Jan 2012
Posts: 3,811
Likes: 14
From: Lake Fork TEXAS
After much debating over the look
I decided to have the rear raised back up a 1/2 inch , the aftermarket lowering bolts are great , but it was bottoming out so this is what we came up with ...
Thread Starter
Safety Car
Joined: Jan 2012
Posts: 3,811
Likes: 14
From: Lake Fork TEXAS
Thread Starter
Safety Car
Joined: Jan 2012
Posts: 3,811
Likes: 14
From: Lake Fork TEXAS
It's taken a lot of patience , I started with the tire rim deal , they rest falls into place lowered it on the fac. bolts then had aftermarket bolts installed
Dropped it as far as it would go , then just made a few adjustments in the height ..
Dropped it as far as it would go , then just made a few adjustments in the height ..
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Melting Slicks
Joined: Jan 2007
Posts: 3,021
Likes: 133
From: Conejo Valley CA
I'm lowered to the bottom on the stock bolts. Definitely low enough. I scrape a lot so I can't imagine having it any lower. I don't think you'll regret raising that 1/2 inch in the rear.
Thread Starter
Safety Car
Joined: Jan 2012
Posts: 3,811
Likes: 14
From: Lake Fork TEXAS
I done the side markers myself and the reverse lights the rears I sent out to have them smoked
