Coolant crossover pipe under intake
Thread Starter
Instructor
Joined: May 2012
Posts: 166
Likes: 0
From: Charleston WV
Coolant crossover pipe under intake
Just need clarification on a problem I am having.. I put an LS6 intake on my 00 Corvette. If memory serves I used the stock coolant lines under the intake (the type that has a metal line running under the intake to the back two holes).. And again if memory serves me correctly I had rubber "O" rings as seals but eveything I am googling shows little metal "tabs" with an O ring type of seal in them.. I dont remember these on my car at all and could quite possibly be the cause of my coolant leak 
So on a LS1 with the stock coolant lines do I need these??
Product in question
http://www.autozone.com/autozone/par...1_169496_2826_
So on a LS1 with the stock coolant lines do I need these?? Product in question
http://www.autozone.com/autozone/par...1_169496_2826_
Burning Brakes
Joined: Jul 2006
Posts: 968
Likes: 12
From: Regina Sask
Some use the metal gaskets with the o-rings, and some just use o-rings. Look at the under side of the coolant pipes, if their flat, use the gasket type. And if there is a groove, use the o-rings.
Russ Kemp
Russ Kemp
