[Z06] Problem! Need help please :) (Slave cylinder)
Thread Starter
Racer
Joined: Feb 2014
Posts: 298
Likes: 0
From: Detroit Michigan
Problem! Need help please :) (Slave cylinder)
Okay long story short, removed LS6 from the top.
Left the bellhousing/ clutch on the block and pulled out.
Torque tube was still installed and supported.
Accidently pressed the clutch pedal to the ground while clutch /flywheel /bellhousing wasn't connected.
Did my work and reinstalled motor/ bellhousing into car and onto torque tube.. Didn't think to check the slave cylinder or anything.
After install was complete clutch pedal doesn't build pressure and I see clutch fluid leaking from the bell housing..
What's my course of action ?
New slave?
Remove trans/tube and bleed it first?
Left the bellhousing/ clutch on the block and pulled out.
Torque tube was still installed and supported.
Accidently pressed the clutch pedal to the ground while clutch /flywheel /bellhousing wasn't connected.
Did my work and reinstalled motor/ bellhousing into car and onto torque tube.. Didn't think to check the slave cylinder or anything.
After install was complete clutch pedal doesn't build pressure and I see clutch fluid leaking from the bell housing..
What's my course of action ?
New slave?
Remove trans/tube and bleed it first?
