Lingenfelter 2 step question
Thread Starter
Racer
Joined: Oct 2008
Posts: 349
Likes: 18
From: SoCal
Lingenfelter 2 step question
Is there a way to put a switch in line with the LNC003 so I could deactivate the unit in the burnout box and then turn it on to launch and shift? I have a blower so I'm gonna want the unit set low to launch and I bet it'll make burnouts nearly impossible
Pro
Joined: Mar 2009
Posts: 525
Likes: 21
6 Speed? I don't see why you couldn't interrupt the neutral/clutch switch so it won't know the clutch is down when you do your burnout.
Thread Starter
Racer
Joined: Oct 2008
Posts: 349
Likes: 18
From: SoCal
Yeah 6 speed. I had an MSD one on my Camaro and when I put a switch in the clutch line things went to ****. I have the pedal block to limit clutch travel so after 1" or so I'm engaged.
I ordered it anyway. I'll figure some thing it worst case. I was hoping someone would see this and had already done it
I ordered it anyway. I'll figure some thing it worst case. I was hoping someone would see this and had already done it
Advanced
Joined: Aug 2011
Posts: 97
Likes: 1
I just did this with mine. What you do is you run the 12v+ that comes from your clutch switch to your yellow wire on the lingenfelter 2 step on my LLC-2000. you just put a switch in line witch that wire and your done. If your still confused let me know I will pm you a diagram.
Thread Starter
Racer
Joined: Oct 2008
Posts: 349
Likes: 18
From: SoCal
I just did this with mine. What you do is you run the 12v+ that comes from your clutch switch to your yellow wire on the lingenfelter 2 step on my LLC-2000. you just put a switch in line witch that wire and your done. If your still confused let me know I will pm you a diagram.
