[Z06] katech coil relocation brackets and cast AL valve covers
Thread Starter
Instructor
Joined: Apr 2003
Posts: 115
Likes: 0
From: Pittsburgh
*PHOTOS* katech coil relocation brackets and cast AL valve covers
hi all,
just wondering if anybody has tried the katech coil relocation brackets and cast aluminum valve covers yet?
i think the cost was around $800 for the valve covers and coil relocation brackets... i'll check on that, but it seemed kinda high.
i figured i could take the stock valve covers and grind the bosses for the coil brackets off and then polish them on a wheel and make them look nice-- just wish they were taller. :(
heres some photos:
more photos:
http://home.earthlink.net/~maz222/ls1vc.jpg
http://home.earthlink.net/~maz222/ls1vc.jpg
http://home.earthlink.net/~maz222/ls1vc.jpg
http://home.earthlink.net/~maz222/ls1vc.jpg
[Modified by ppk1911, 7:11 PM 7/14/2003]
just wondering if anybody has tried the katech coil relocation brackets and cast aluminum valve covers yet?
i think the cost was around $800 for the valve covers and coil relocation brackets... i'll check on that, but it seemed kinda high.
i figured i could take the stock valve covers and grind the bosses for the coil brackets off and then polish them on a wheel and make them look nice-- just wish they were taller. :(
heres some photos:
more photos:
http://home.earthlink.net/~maz222/ls1vc.jpg
http://home.earthlink.net/~maz222/ls1vc.jpg
http://home.earthlink.net/~maz222/ls1vc.jpg
http://home.earthlink.net/~maz222/ls1vc.jpg
[Modified by ppk1911, 7:11 PM 7/14/2003]
Supporting Vendor
Joined: Mar 2002
Posts: 13,099
Likes: 672
From: Bristol, Tennessee
St. Jude Donor '09
Re: *PHOTOS* katech coil relocation brackets and cast AL valve covers (ppk1911)
You need to contact Debbie and get a new Transision coupler for your Halltech MAG to TB. That short one has been the code bringer. It was sent out on a few T-1s by mistake and is the reason for 99% or the codes we saw on the T-1.
Free upgrade.
Debbie@HalltechSystems.com
Jim
Free upgrade.
Debbie@HalltechSystems.com
Jim
Thread Starter
Instructor
Joined: Apr 2003
Posts: 115
Likes: 0
From: Pittsburgh
Re: *PHOTOS* katech coil relocation brackets and cast AL valve covers (Jim Hall)
say again? i think you've got my setup confused with somebody else. the only mods on my car (intake side that is) are a carbon air bridge and blackwing... got the stock MAF 'n stuff.
