[Z06] quality control on the Z
Thread Starter
Melting Slicks
Joined: Dec 2003
Posts: 2,334
Likes: 11
From: las vegas nv.
quality control on the Z
I went to see my friends 01Z,thus last weekend. He ordered this car and because of his health he doesnt drive much. 1,200 miles like brand new. Anyway I see where the front bumper cover dors not line up with the drivers side headlight. The gap is closer on one side, also the drivers door upper edge next to the front windshield curves in about a quarter of an inch closer than the pass. side. Are these typical on Z's. Thx.
Melting Slicks
Joined: Jul 2003
Posts: 2,563
Likes: 0
From: All Liberals must hang
St. Jude Contributor
Re: quality control on the Z (bobby777)
Just seeing if most z's have bad fitting panels! How is your's dudya? :cool:
No Ribbing intended. :p:
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Le Mans Master
Joined: Nov 2001
Posts: 6,984
Likes: 0
From: Central Coast CA
Re: quality control on the Z
You think panels lining up are bad, take a look at the black panels in the rear lid or under the hood and wheel well. Mine look rough and scratched in some areas. I would think for $50k they would be smooth and polished.
Instructor
Joined: Nov 2003
Posts: 124
Likes: 0
From: FLA
Re: quality control on the Z (DRMitchell)
Bobby,
the nose and rear facia are easily adujstable.
the nose and rear facia are easily adujstable.
How true. If it bothers you, take it to have plastic surgurey. :rofl: :rofl: :rofl: :rofl: :rofl: :rofl: :rofl: :rofl: :rofl: :rofl: :rofl: :rofl: :rofl: :rofl:
Burning Brakes
Joined: Mar 2003
Posts: 954
Likes: 0
Re: quality control on the Z (DRMitchell)
Bobby, the nose and rear facia are easily adujstable.
all the body panels and facias have adjustments.
the new corvette is cheaper than my american made SUV so the adjustments were no big deal.
:cheers:
