FS: Ed Curtis Hellion Cam
#1
Pro
Thread Starter
Member Since: Apr 2006
Location: New Bern NC
Posts: 742
Likes: 0
Received 0 Likes
on
0 Posts
FS: Ed Curtis Hellion Cam
I decided to go a different route with my cam. I'm wanting to spin to 7200 and this one is good to about 6800. This one has been installed for a few dyno pulls and ~100 miles..... I did 501RWHP 456RWTQ in my 383. Good springs and heavy duty pushrods are highly reccommended.
The specs are 243/247 .629/.629 112+4.
This cam cost me $480 overnighted.... will let it go for $360 shipped
BTW, if your setup can use some 7.325 pushrods I'll include a set of like new Manton 3 piece 5/16 .095 wall pushrods for another $110... these are the bad of the bads and normally cost ~$170.
Note: The cam is still installed but will pull it out once my replacement cam gets here.
The specs are 243/247 .629/.629 112+4.
This cam cost me $480 overnighted.... will let it go for $360 shipped
BTW, if your setup can use some 7.325 pushrods I'll include a set of like new Manton 3 piece 5/16 .095 wall pushrods for another $110... these are the bad of the bads and normally cost ~$170.
Note: The cam is still installed but will pull it out once my replacement cam gets here.
Last edited by LETHL_C6; 02-23-2007 at 08:10 PM.
#5
Pro
Thread Starter
Member Since: Apr 2006
Location: New Bern NC
Posts: 742
Likes: 0
Received 0 Likes
on
0 Posts
No takers just yet. A few people have asked if it will fit under stock heads. It should be fine but you will have to check the clearance to be 100% sure.