FS: Fast 102 with nw102 for sale
#1
Advanced
Thread Starter
Fast 102 with nw102 for sale
I have a FAST102/NW102 intake and throttle body for sale. tried installing on my LS6 with A&A blower and the throttle body will not fit so here I am selling it. it is professionally painted Yellow comes with FAST fuel rails in red and fuel line kit in black. comes with fittings to connect to factory fuel line. comes with harness for LS1 application. has fuel pressure gauge and all hardware. fresh gasket just installed between the lid and base. also comes with 4" rubber reducer for your throttle body to mass air or air inlet tube and clamps. see pics and email or text with any questions >>>>>>>>>asking $1400 shipped<<<<<<<<<<<<
#2
NCM Lifetime Member
Member Since: Aug 2015
Location: Cunningham, TN
Posts: 4,970
Received 3,930 Likes
on
2,015 Posts
2021 Corvette of the Year - Modified
2020 C5 of the Year Winner- Modified
C5 of Year Finalist (appearance mods) 2019
St. Jude Donor '18-'19-'20-'21-'22-'23-'24
That's a nice setup brother! It wouldn't fit with the throttlebody flipped 180 degrees?
#3
Advanced
Thread Starter
here is the issue when I flip the throttle body it won't sit flush because the throttle body has a lip also if you notice the bottom side of the throttle body has a flat spot to clear the water pump the top is round and when I flip it would hit the pump. I'm not sure if this is an older style NW102 or what but it won't flip
#4
NCM Lifetime Member
Member Since: Aug 2015
Location: Cunningham, TN
Posts: 4,970
Received 3,930 Likes
on
2,015 Posts
2021 Corvette of the Year - Modified
2020 C5 of the Year Winner- Modified
C5 of Year Finalist (appearance mods) 2019
St. Jude Donor '18-'19-'20-'21-'22-'23-'24
PM sent
#6
Can you grind the throttle body and grind the water pump to make clearance?
I'm kinda tempted to buy it but I'd just run into the same problem you ran into, so I'd rather figure out how to make it fit first, even if that means you keep it installed.
I'm kinda tempted to buy it but I'd just run into the same problem you ran into, so I'd rather figure out how to make it fit first, even if that means you keep it installed.