LS1 Edit HELP! Comm Error?
Thread Starter
Racer
Joined: Nov 2005
Posts: 299
Likes: 0
From: Portland OR
LS1 Edit HELP! Comm Error?
Have an 02 Z06 that we just put TSP Longtubes on. Fired up the LS1 edit to disable the rear 02 sensors, it says connection established reading VIN then continually flashes "comm err: attempting to re-establish connection with PCM". On the dash it flashes "reduced power mode, service traction system, etc". Anyone know what to do? 
Last edited by HolyShiznit; Jan 22, 2007 at 09:58 PM.
Le Mans Master
Joined: Aug 2005
Posts: 5,375
Likes: 328
From: CA.
St. Jude Donor '13-'14-'15
Hmmmm strange-----did you do any welding during the instalation ???--It is a good idea to disconnect the battery when welding ---Could have blown a fuse somwhere---check O2 sensor fuses--and plugs---wiring--then disconnect battery for 1-2 hours--try again---------
