Crane cams? What do you know??
Thread Starter
Instructor
Joined: Jan 2005
Posts: 131
Likes: 0
From: Port Orange Florida
Crane cams? What do you know??
I have a good freind that works at Crane Cams here in Daytona. He can get me his cost on any Crane product. 
I just never hear you guys talking about them in these forums. Any info or your thoughts on them would be very helpful. I know VHR (Vinci Hi Performance) works with Crane and uses them in Orlando. Will go in on a 02 Z06 with LT headers and Ti cat back. Thanks
I just never hear you guys talking about them in these forums. Any info or your thoughts on them would be very helpful. I know VHR (Vinci Hi Performance) works with Crane and uses them in Orlando. Will go in on a 02 Z06 with LT headers and Ti cat back. Thanks
Melting Slicks
Joined: Jul 2004
Posts: 3,092
Likes: 120
From: orlando florida
St. Jude Donor '15
what do you want to know? if the rocker work like they say they do? well they did on the wife's 99 formula. i've posted the graphs before. dyno 9 was before dyno 11 was about 500 miles after. then dyno 14 was 8 months later 1/20/05 comparing dyno 9 and 11 i gained 11/13. then comparing dyno 9 and 14 i gained 17 rwhp.
do not pay attention to the peak torque as there was a spike at the beginning of the run.
do not pay attention to the peak torque as there was a spike at the beginning of the run.
Melting Slicks
Joined: Feb 2001
Posts: 2,137
Likes: 1
From: Oklahoma City OK
Cruise-In III Veteran
Until I closed my race shop about 6 years ago I would only use Crane cams and lifters. I never had one go bad and never had one more than 1/2 degree off when I degreed them in. Most were 0/0 spot on.
