Alky-pump wiring-Switched Power
Thread Starter
Race Director
Joined: Jan 2003
Posts: 14,285
Likes: 0
From: Houston, Tx Got traction?
CI 5-6-7-8-9-10 Veteran
St. Jude Donor '07-'08
Alky-pump wiring-Switched Power
Hey all, i wired up my alky pump i used the accessory plug <obviously not enough power> When i turn the key the car won't turn over, if i unplug the alky the car will start no problems.
Where should i pull the switched power for the alky pump? Or can i run the pump to an always on source and turn the kit on on my own?
Chris
Where should i pull the switched power for the alky pump? Or can i run the pump to an always on source and turn the kit on on my own?
Chris
Burning Brakes
Joined: Sep 2001
Posts: 1,005
Likes: 6
From: Denver, NC
Alky Problem
Instructions should have told you to use the "hot when ignition is on" wire on your ignitioon switch. This way you get full power and system is only on when car is running....
Just installed mine.
Just installed mine.
Race Director
Joined: Sep 2003
Posts: 13,550
Likes: 6
From: Now in God's Country, the Big Sky, Montana!
Cruise-In 7-8-9-10 Veteran
St. Jude Donor '06-'07-'08-'09-'10-'11-'12
I wired mine in with the ignition switch main feed. Plenty of power. It is the big orange wire. Probably about 10 gauge in size.
Thread Starter
Race Director
Joined: Jan 2003
Posts: 14,285
Likes: 0
From: Houston, Tx Got traction?
CI 5-6-7-8-9-10 Veteran
St. Jude Donor '07-'08
Originally Posted by js23881
Instructions should have told you to use the "hot when ignition is on" wire on your ignitioon switch. This way you get full power and system is only on when car is running....
Just installed mine.
Just installed mine.
