When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hi Corvette Lovers:
Would Someone Out There Please Explain How To Remove & Install A Multifunction Switch,on A 1998 C5 Corvette?
Thank U
Carlos
If you're referring to the turn signal switch, here's a thread http://forums.corvetteforum.com/show...unction+switch
...on that switch. I've not had to change one yet, but I do have the Corvette Service Manuals and I'm sure there are detailed instructions in there...
OK this is gonna be really vague since it was last year I did this, but under the steering column there are a couple screws that need to be removed that will drop the bottom cover. I think there is another screw or two you need to take out to get the top half off.
Then there are 2 or 3 torx head screws that hold the signal switch to the steering column. Those were the hardest part just because they're at funky angles. One from the top and one head on. I think I ended up using a flat head screwdriver that would fit in the torx notches to help get them out. The electrical connections are pretty obvious, the main connection and then a second small one that are all the typical snap together connectors.
It really wasn't too bad. I would guess an hours worth of work start to finish if doing it the first time.
THANK U!! GUSTO AND RICH:
YOU GUYS ARE TWO ANGELS ON EARTH!
THANK U BOTH FOR THE HEADS UP!!!
THE INFO YOU BOTH GAVE ME WAS EXACTLY WHAT I NEEDED!!
THANK YOU ONCE AGAIN
AND MAY GOD BLESS BOTH OF YOU ALWAYS!!!
Designer Imagines A Corvette That Looks More Like a Corvette Than the Corvette
Slideshow: A Jaguar designer's personal project imagines what a modern front-engined Corvette might look like if Chevrolet revisited the golden age of the Stingray.