shifter knob question
Advanced
Joined: May 2001
Posts: 76
Likes: 0
From: Kansas City MO
Re: shifter **** question (curvett94)
If it is the same as a 2000 or 2001, the insert with the shift pattern will pull out. Use a flat screw driver to ease it up. Underneath that is a pin with a "T" shape to it that keeps the **** straight and from turning. Use a pair of needle nose plyers to pull it stright up and out. The **** will then screw off.
Melting Slicks
Joined: Nov 2000
Posts: 2,200
Likes: 0
From: Atlanta, Ga USA
Re: shifter **** question (curvett94)
Complete instructions in the Tech Tip section.
I use the two screwdriver technique rather than the vise grips, comes off easily, then the **** unscrews. I use teflon tape around the shaft before screwing on the new ****. It holds without having to be screwed overly tight.
I use the two screwdriver technique rather than the vise grips, comes off easily, then the **** unscrews. I use teflon tape around the shaft before screwing on the new ****. It holds without having to be screwed overly tight.
