Air Temp Sensor
Thread Starter
Le Mans Master
Joined: Sep 2001
Posts: 5,022
Likes: 1
From: TEXAS
Air Temp Sensor
I'm trying to install a Donaldson Blackwing. I'm not sure how to disconnect the ATS on the MAF. So, what do you pry up or poke or prod? :confused: :confused: :confused: :confused:
Melting Slicks
Joined: Feb 2000
Posts: 2,375
Likes: 0
From: Pittsburgh, PA
Re: Air Temp Sensor (123Gone)
The only thing you need to remove is the harness plug going into the MAF. It has a grey plastic retaining clip that you can use a thin blade screw driver on to gently lift and then pull back to remove. Once the retaining clip is removed pull the harness plug out. It is tight because of the weather pack connector.
Be sure to hold the plastic plug to pull and not the wires.
Be sure to hold the plastic plug to pull and not the wires.
