When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I'm finishing up an install right now with their 3" x pipe. In my opinion they are good quality. Be prepared to cut your tunnel plate so that the O2 sensors can clear. The install is not bad. I used instructions on ls1howto.com for the FLP headers. You will need to unbolt the starter. For me the passenger side was tougher to get in than the drivers side.
mine hang down about an inch and a half below the car and are beat up because there so low, i had dynatechs on my last vette and they were flush with the bottom of the car and i had no issues
Sorry guys we're waiting on 3" x pipes right now. I hope to get them asap!
Jason
hey jason its chris, you never called me back again about mine hanging so low, i know you said you were gonna look at some other sets and brands then call me back, please let me know whats going on