need catback install advice-please!
Thread Starter
Burning Brakes
Joined: Jul 2007
Posts: 864
Likes: 2
From: Jax FL
need catback install advice-please!
I asked this question before and you all where generous with your replies and advice.....so please help me again, I have purchased a z06ti catback that was removed by being cut just beyond the muffler inlets and I want to install on coupe-my question is: how high do I have to raise the car up to remove the old (assuming I cut off at the muffler inlets) how high do I need to raise the car?.....I know you'll told me that if they where one peice that I needed from 3 feet to 40 inches but I have 2 peices so I am thinking I might not have to get it so high??
...and yes I will have couplings mig welded to the ti exhaust intlets and then clamp the the pipes.
Thanks for your help-again!
Thread Starter
Burning Brakes
Joined: Jul 2007
Posts: 864
Likes: 2
From: Jax FL
Racer
Joined: Mar 2005
Posts: 454
Likes: 1
From: Portland Oregon
If you want to take it off clean you need to get it about 40" off the ground. Less if you are going to cut it. I have always done it up in the air so I cant help with the sway bar issue, but its VERY easy to undo so its really not an issue if you find it wont slip past.
-Ken
-Ken
