Help from Z06 Guys...
Thread Starter
Instructor
Joined: Feb 2006
Posts: 133
Likes: 0
From: Leesburg VA
Help from Z06 Guys...
I'm about to install Z06 brake ducts on my vert. I have the template, but I want to verify the location measurements so that I have scoops properly located before I cut. Can one the Z06 guys make the measurements as shown in the following pic? (I borrowed the pic from Glennm27's intall guide):
Thanks in advance,
Dave
Thanks in advance,
Dave
Instructor
Joined: Aug 2007
Posts: 185
Likes: 2
From: Bay City Texas
I'm about to install Z06 brake ducts on my vert. I have the template, but I want to verify the location measurements so that I have scoops properly located before I cut. Can one the Z06 guys make the measurements as shown in the following pic? (I borrowed the pic from Glennm27's intall guide):
Thanks in advance,
Dave
Thanks in advance,
Dave
Ewww, maybe shouldn't have done that. Y'all can see that I actually drive the car and am not really **** about keeping it spotless. Oh, well.
Last edited by jss812; Feb 17, 2008 at 12:13 PM.
Thread Starter
Instructor
Joined: Feb 2006
Posts: 133
Likes: 0
From: Leesburg VA
<<Y'all can see that I actually drive the car and am not really **** about keeping it spotless.>>
Better than keeping it spotless and not driving it...
Awesome!!! That's perfect - you even got the color right!!!
Thanks alot - I appreciate the help!!!
Dave
Better than keeping it spotless and not driving it...
Awesome!!! That's perfect - you even got the color right!!!
Thanks alot - I appreciate the help!!!
Dave
Last edited by D2Brewing; Feb 17, 2008 at 11:52 AM.
Instructor
Joined: Aug 2007
Posts: 185
Likes: 2
From: Bay City Texas
I was wanting to take a few pics of the badges and went ahead and got your shots while I was add it. Glad to be of some help.
Instructor
Joined: Aug 2007
Posts: 185
Likes: 2
From: Bay City Texas
Please check the dimension to the curve again. I apparently can't read a scale. I originally said 11/16. It really is 9/16 to the edge of the rocker panel.
