Flip Tie PDF
Melting Slicks
Joined: Jun 2004
Posts: 2,453
Likes: 81
From: Fishin' Pole FL
Melting Slicks
Joined: Jun 2004
Posts: 2,453
Likes: 81
From: Fishin' Pole FL
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Intermediate
Joined: Jun 2008
Posts: 28
Likes: 0
From: Parrish FL
I like the mod
Thanks for the great write-up on the this mod. I did it today and I noticed a definite increase in throttle response. I will head to the track in about a week and see if there are any improvements. Seems like a great alternative to paying $300 on an aftermarket part with similar design.
Le Mans Master
Joined: Dec 2001
Posts: 7,788
Likes: 6
From: Winchester TN
Cruise-In III Veteran
Cruise-In IV Veteran
Cruise-In V Veteran
St. Jude Donor '03-'04-'05-'06-'07-'11
Hi maximum -
If I were starting over, I would have done the flip-tie and saved a ton of cash.
I like the idea of the mod, and the panel you have to cut is readily replaceable if you decide to go another route.
best regards -
mqqn
If I were starting over, I would have done the flip-tie and saved a ton of cash.
I like the idea of the mod, and the panel you have to cut is readily replaceable if you decide to go another route.
best regards -
mqqn
Race Director
Joined: May 2005
Posts: 15,960
Likes: 21
From: West Norriton PA
St. Jude Donor '08
