strange noise coming from behind dash during CLB install...
Thread Starter
Instructor
Joined: Jul 2008
Posts: 161
Likes: 0
From: Cincinnati
strange noise coming from behind dash during CLB install...
so i just got done installing the CLB... but i heard a strange noise while doing the install. once i turned the key to "on" and then pulled fuse #25, when i got back under the dash to pull the CL connector, i could hear a strange noise coming from somewhere behind the dash. it sounded like an intermittent clicking noise, almost like an actuator was trying to drive or something. i got everything installed and put the fuse back in, turned the key to "on" again and the noise was still there. i then cleared all of the codes in the DIC from pulling the fuse, started the car up for a few seconds... CLB works great. waited a few minutes, got back in the car and turned the key to "on" with the door shut and no more noise. i'm confused and a little bit worried, so if anybody has any thoughts i would appreciate some feedback. thanks...
-jake
-jake
Thread Starter
Instructor
Joined: Jul 2008
Posts: 161
Likes: 0
From: Cincinnati
i went back out to the car about an hour later, and turned the key to "on", heard the same noise again. i am thinking that maybe this has something to do with the HVAC system? i had the system turned off, but could it still be adjusting? the noise lasted for about 20 seconds and then i didn't hear it anymore...
