Installed A & A frame savers
Thread Starter
Le Mans Master
Joined: Oct 2001
Posts: 5,577
Likes: 3
From: Southern Maryland Maryland
Installed A & A frame savers
I just installed A & A frame savers and man they are easy to install. Installation is straight forward, first you drill a 5/8" hole in the bar and bolt the housing to the skid bar without a wheel. I grinded off the paint and welded a bead on the front of the housing. Finally you bolt the wheel in place.
My question is do most people who lower their car cut the black lower airdam portion in the front?
My question is do most people who lower their car cut the black lower airdam portion in the front?
Team Owner
Joined: Dec 2001
Posts: 33,865
Likes: 0
From: Last - We are with you my friend
St. Jude '03-'04-'05-'06-'07-'08-'09-'10-'11
Re: Installed A & A frame savers (Phil97SVT)
Phil, some of the guys in this forum have cut anywhere from 3/4 " to 1" of the rubber :yesnod:
Platinum Supporting Vendor
Joined: Sep 2001
Posts: 5,730
Likes: 270
From: VENTURA Ca
Re: Installed A & A frame savers (Phil97SVT)
Phil That's a 5/16" hole that's drilled into the bar. I like to shave the air dam after lowering and installing the Frame Savers. I have no problems going just about anywhere and my car's pretty low.
