GM part# help

Reply Subscribe

Thread Tools

Search this Thread

Jan 30, 2009 | 01:14 PM

SkyWarp

Thread Starter

Pro

Joined: Feb 2006

Posts: 587

Likes: 0

From: Toronto Ontario

GM part# help

I was wondering if anyone knew the part# for the temp sensor cover (the plastic peice beside the ignition on the radio bezel) thanks alot

Rob

Jan 30, 2009 | 04:36 PM

jovette

Melting Slicks

Joined: Feb 2006

Posts: 2,172

Likes: 104

From: Des Moines Iowa

I've got it at home, but am at work right now. If you have the cover and the broken tab, assuming that's what broke on it, you can repair with two part expoxy. (at least that's what I did and it worked great.) Just ruff up the area around, but not on point of contact, with sand paper, then clean with dawn dish soap and warm water, dry, and then epoxy the two pieces back together. You can 'build up' the area around the break with the epoxy, and make it stronger than when new!

Jan 30, 2009 | 04:48 PM

ajcorvettes

Pro

Joined: Dec 2008

Posts: 513

Likes: 0

From: Essexville MICH

Quote:

Originally Posted by SkyWarp

I was wondering if anyone knew the part# for the temp sensor cover (the plastic peice beside the ignition on the radio bezel) thanks alot

Rob

My part numbers go up to 02 and for 02, it says 10268306 That should get you where you need to go. It really shouldn't have changed over the years. Good luck!

P.S. $9.42 at GMpartsdirect.com

Last edited by ajcorvettes; Jan 30, 2009 at 05:04 PM. Reason: location

Jan 30, 2009 | 05:53 PM

The Wrench

Burning Brakes

Joined: Oct 2004

Posts: 931

Likes: 35

From: Rowlett, Texas

Hint: put just a touch of grease on the tabs before you instasll it. It will slip on with less stress, and come off without breaking next time, if you're lucky.

DG

Reply Subscribe

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Reply Share

First
Prev
1 / 1
Next
Last

Forum Jump