oil pressure pegged
Thread Starter
Racer
Joined: Nov 2008
Posts: 251
Likes: 1
From: Pensacola Florida
oil pressure pegged
OK CF readers , my oil pressure is pegged out so of course I need a new sending unit. I have two questions , do I need to remove the intake to replace it or can I get to it without doing that, not going to cut anything to get to it. Also is a GM switch ok or do you guys prefer some other brand of switch. I guess I should also throw in that its a 02 coupe 6 speed and I also have the use of a lift at work. Thanks for any advice
Melting Slicks
Joined: Feb 2007
Posts: 3,266
Likes: 8
From: Indian Rocks Beach FL
St. Jude Donor '08-'09-'10
Yes, you have to remove the intake unless you cut out a section of the cowl. I went the remote mount way with the Buick sensor. It's a pricey way to go but if it ever quits again it's a 5 minute fix.
Le Mans Master
Joined: Feb 2002
Posts: 6,937
Likes: 21
From: Waldorf MD
No, the intake gaskets are "rubber o-rings" and can be re-used.
You will need a very "low" torque wrench final for intake bolts. 44 INCH-lbs (first pass) and 89 INCH-pounds (final pass), read INCH not FOOT.
You will need a very "low" torque wrench final for intake bolts. 44 INCH-lbs (first pass) and 89 INCH-pounds (final pass), read INCH not FOOT.
Last edited by Oldvetter; Feb 8, 2009 at 06:48 PM.
Tech Contributor
Joined: Jan 2007
Posts: 19,465
Likes: 1,167
From: Dyer, IN
Race Director
Joined: Jul 2004
Posts: 16,795
Likes: 62
From: Lake Havasu City, AZ
