Fast 92 Help
Thread Starter
Safety Car
Joined: Jul 2007
Posts: 4,456
Likes: 29
From: Wichita Falls Texas
Fast 92 Help
I just installed my fast 92 and when i start the car the rpm sits around 1500. Then it settles down to normal 750 in about 20 seconds. Then i go drive it and all is good for the first 5 minutes, then everytime i put it in neutral the rpm sits around 2000 then slowly comes down to 750 when stopped.
Do you think this is cause of my tune, or do you think it has a leak.
Is there something i can spray on it when its running to see if it has a leak.
Thanks for any help
Do you think this is cause of my tune, or do you think it has a leak.
Is there something i can spray on it when its running to see if it has a leak.
Thanks for any help
Burning Brakes
Joined: Jan 2007
Posts: 833
Likes: 2
From: Boca FL
Racer
Joined: Jan 2006
Posts: 273
Likes: 0
From: Ithaca Michigan
If you think you have a leak take your propane torch and dont lite it, just turn the gas on and point it where you want to check. Enging will rev when fuel (propane) hits the leak. I'd pull the intake and check for Orings out of place and make sure your knock sensor wires and burp tube for the heads is not holding the intake (up) from sealing correctly.
Good luck
Good luck
