DMH cutouts...switch install??
Thread Starter
Pro
Joined: Jun 2000
Posts: 706
Likes: 1
From: Granby MA
Cruise-In I Veteran
Cruise-In II Veteran
DMH cutouts...switch install??
Im installing a set of DMH low profiles next weekend but i wanted to get some info about how to bring the wires into the cab. I sapose i can bring them in from the rear however its going to be kinda hard seeing as the cutouts are getting installed on the rear 2 pipes just behind the doors. I really dont want to go through the hassle of removing the tunnel plate in order to access the shifter....anyone have any ideas or pics of there install?...Thanks!
Le Mans Master
Joined: Feb 2003
Posts: 6,683
Likes: 144
From: Memphis Tennessee
I had my DMH's installed, but I do remember the installer telling me that he came into the interior in the rear. It would make sense so that the wires are a bit more protected from heat.
By the way, I LOVE mine.
By the way, I LOVE mine.
Team Owner
Joined: Jan 2004
Posts: 23,220
Likes: 3
From: HOUSTON
St. Jude Donor '06 thru '15, '19
thats what I did, throught the shifter the towards the back of the car, no holes to cut, piece of cake.
Team Owner
Joined: Jan 2004
Posts: 23,220
Likes: 3
From: HOUSTON
St. Jude Donor '06 thru '15, '19
I dont but if I remember right, feed it downt the shifter hole on the right side, then towards the back, it will drop out at the rear of the tunnel plate, I used a coat hanger , then taped the wires to it and pulled it through.
