Turn signals not working
Thread Starter
Heel & Toe
Joined: Apr 2009
Posts: 18
Likes: 0
From: Andrews Texas
Turn signals not working
I have a 2000 FRC vette, after doing my nitrous install my turn signals just stoped working so I turned here to look for answers and found some solutions. I took the turn signal switch apart and cleaned the inside checked the all the tabs and it started working again but the next day they stoped again so I figured it was the switch. I have bought and replaced the turn signal switch, Hazard switch, and installed the hyper flash harness and still not working. Im going to clean all the grounds and hope that fixs it. Anyone else have this problem after replacing everything?
Thanks
Thanks
Thread Starter
Heel & Toe
Joined: Apr 2009
Posts: 18
Likes: 0
From: Andrews Texas
No click and nothing comes on in the cluster. Hazard lights work fine but just no turn signals, not even the green arrows in the cluster light up.
Pro
Joined: Aug 2010
Posts: 622
Likes: 169
From: Montgomery Texas
You may want to have a look at fuse #15 and #8 in the passenger compartment fuse box.
Also, in the course of installing the NOx, if you messed about with any of the pedals, you may want to have a look there. The T/S switch gets an input from the stop lamp switch.
Also, in the course of installing the NOx, if you messed about with any of the pedals, you may want to have a look there. The T/S switch gets an input from the stop lamp switch.
