Corbeau A4 seat install
Thread Starter
Drifting
Joined: Jun 2004
Posts: 1,565
Likes: 5
From: Mechanicsville VA
St. Jude Donor '08
Corbeau A4 seat install
Installed the passenger side seat today. Used the following post for the install: http://forums.corvetteforum.com/c5-t...errerid=248617. Varied some from a few of the steps. Started off test fitting the seat mount in the car prior to installing on the seat. Fit like a glove. Used the rest of the instuctions for assemblying everything. Took some trial and error to get the seat in the car. Easiest way to install the seat in the Z06 was to position the seat back as you would use it while driving. Seat went right in. Here's where the problem started. Could bolt the seat down in the front and left rear. No go with the right rear. Turns out the vertical strut for the R&D crossbar does not allow the seat rail to go down enough to start the nut. May try and round the ends of the seat rail and see if that will work. One other variance was I could NOT use the 2 5/8"
washers on the rear as in the instructions. Other than that , it went good. Will get pic tomorrow.
Gene
washers on the rear as in the instructions. Other than that , it went good. Will get pic tomorrow.
Gene
Last edited by 71corv; Dec 14, 2012 at 11:26 PM. Reason: add the word "not"
