Pcm removal
Thread Starter
Racer
Joined: Apr 2013
Posts: 389
Likes: 204
From: LIMA OHIO
Pcm removal
hello friends i need to remove my pcm on my c5 and was wondering if there any helpful tips out there before i screw something up , lol , i have to remove and send away to get a fault code taken out after sc install , any tips would be appreciated , thx , keep cruising 
Le Mans Master
Joined: May 2007
Posts: 5,393
Likes: 17
From: Belleville Mich.
Here is the procedure that I used when I pulled mine.
http://www.eastcoastsupercharging.co...5_corvette.pdf
http://www.eastcoastsupercharging.co...5_corvette.pdf
Pro
Joined: May 2011
Posts: 580
Likes: 1
From: Chicago Suburb
St. Jude Donor '13
Note that the PCM comes out vertically. Also, the 2 rubber gaskets of the RED and BLUE connectors fit around the connectors. They may stay with the PCM when pulled. Put 'em back on the connector when re-installing. Good luck...bit of a pita but not too bad. Also, if you pull the rubber shield from the brake vent, it improves access.
Pro
Joined: May 2011
Posts: 580
Likes: 1
From: Chicago Suburb
St. Jude Donor '13
