P0107, Map sensor
Thread Starter
Burning Brakes
Joined: Sep 2013
Posts: 1,160
Likes: 171
P0107, Map sensor
I just installed an Aeroforce fuel pressure sensor. I tapped into the green wire on the map sensor connector and now Im getting code P0107. I tested voltage on the connector using the orange and gray wires and got 4.97 volts. What did I do wrong??
Thread Starter
Burning Brakes
Joined: Sep 2013
Posts: 1,160
Likes: 171
I tapped into the wrong wire, oops. Gray wire is power. Was doing some research and stumbled across a thread with a diagram. I ran out and clipped the aeroforce sensor wire off the map sensor, cleared the code and took a test drive. No more bucking, hesitating so Im 99% sure that was it.
I had to order a new pigtail so Ill be bribing my neighbor with cash to solder it together.
I had to order a new pigtail so Ill be bribing my neighbor with cash to solder it together.
Race Director
Joined: Mar 2008
Posts: 12,413
Likes: 502
From: Rio Rancho NM
Just curious why you tapped into the map sensor? I have a prosport and all I had to do was hook up wires to power and ground and thread the sensor into the fuel rail. never heard of anyone tapping into the map sensor..
Thread Starter
Burning Brakes
Joined: Sep 2013
Posts: 1,160
Likes: 171
5V, a search I did on this forum before install said that was a 5v source so I used it.
