Under hood light
Thread Starter
Racer
Joined: May 2007
Posts: 313
Likes: 0
From: DES MOINES IOWA
Under hood light
HI FOLKS, THE LIGHT BULB UNDER MY HOOD IS LOOSE, ONLY BEING HELD
IN PLACE BY TWO [ wire brackets] LIKE THESE. I TRY TO GET IT TO
STAY IN PLACE BUT IT WON'T. JUST BLOWS THE #2 FUSE ON MY 01.
IT'S EVEN HARD TO SEE HOW THE BULB IS SUPPOSED TO SIT.
ANY IDEAS OR OPTIONS? THX
IN PLACE BY TWO [ wire brackets] LIKE THESE. I TRY TO GET IT TO
STAY IN PLACE BUT IT WON'T. JUST BLOWS THE #2 FUSE ON MY 01.
IT'S EVEN HARD TO SEE HOW THE BULB IS SUPPOSED TO SIT.
ANY IDEAS OR OPTIONS? THX
Melting Slicks
Joined: Oct 2010
Posts: 3,030
Likes: 794
From: Tollesboro Kentucky
Each of the wires should go over a tab in the light fixture.The tension on the tabs should hold it in place.Unhook the harness in front of the radiator support while you install it to save the fuse.
Intermediate
Joined: Nov 2014
Posts: 41
Likes: 3
From: Cicero NY
Team Owner
Joined: Jul 2006
Posts: 22,192
Likes: 4,180
From: Kannapolis NC
But every time you open a door, it comes on for another 15 minutes. There is a need for a switch if you don't want the light on, such as car shows, repair shop, etc. Mine's unplugged, because as a light it's pretty useless. I carry a small flashlight in the console.
